How act I Install a 2001 Chevy Blazer Ignition Module?
The ignition module in your 2001 Chevy Blazer is prepared up of the ignition switch and the lock cylinder. Provided any of these components mature damaged or bar working exactly, you Testament be unable to begin your vehicle. When this occurs you should remove the parts in succession to install fresh working ones. The ignition switch and lock cylinder can be father in the steering contour.
Instructions
1. Unbarred up the hood of your Blazer. Advice the hood with the hood stands. Fix the battery. Benefit a wrench to loosen the clamp bolt on the detrimental battery terminal. Remove the refusal cable out from the terminal.
2. Use a small screwdriver to unhook the retaining pin and free the ignition module from the steering column.5. Attach the new ignition switch to the new lock cylinder. Press the locking tabs on both of them together until they are firmly locked in place. Lift the steering shove insert off the steering turn.
3. Fix the horn and the air bag. Alteration your hands along the wiring for both of them until you allot their electrical connectors. Disconnect both the horn and the airbag from the steering trundle. Apply a Phillips-head screwdriver to remove the two screws attached to the steering line sleeve. Slide the sleeve off the column.
4. Use a wrench to remove the mounting bolts attached to the ignition switch inside the steering column. Insert your key in to the ignition and move it to the locked position. This will give you access to the retaining pin. Enter the drivers seat of the Chevy. Change your hands approximately the edges of the steering revolve and set the connectors which attach the contain to the shove. Unclip the connectors. Whether you cannot remove them with your hands, custom a flat-head screwdriver to pry them off.
Attach the ignition module back in to the steering column and reattach the steering wheel assembly by following the removal steps in reverse. Connect the negative battery cable back on to the terminal. Turn on the engine to check that the new ignition module works correctly.
