The window regulator is directly latest the door panel.
The aptitude window in your automobile consists of three leading components: the switch window Engine and regulator. The regulator is what is commonly referred to as the track or the lift. When this tool goes evil, it can basis many symptoms, including uneven movement, sudden dropping of the window or no movement at all. There are many diagnostic steps to bias whether the hitch is the power window regulator.
Instructions
1. Dehiscent the door and remove the screws holding the door panel to the door frame. The screws are dark all enclosing the door so assemble trustworthy you carry them all.
2. Pry gone the trim clips at the mould of the door with the trim clip effects. Proceeds all of the clips then pull the panel elsewhere from the door.
3. Disconnect the wiring harness that plugs into the window switch by urgent the locking Press-stud and pulling the harness straight absent.
4. Look the inside of the door to find the motor and frame that the window sits on. Observe the movement of the cable and the pivot points on the window regulator as the motor spins. If the cable appears to slip or the pivots point are loose, this means that the regulator will need to be replaced.
6. Position the car battery near the door and use the wire to connect the positive and negative terminals of the battery to the window motor. Watch the window motor closely to make certain it is operating.
7. This is the window regulator.5. Disconnect the window motor wiring harness from the vehicle.
