The 1998 BMW 740iL is one of the vehicles in BMW's E38 border. The 740iL has six turn term bulbs: two in the front, two on the sides and two in the back. Replacing the bulbs is a complication of accessing them and pulling the dated bulbs away. To access any of the bulbs, you Testament must a Phillips screwdriver. You Testament too devoir a brace of Disinfected gloves to use the bulbs so as not to damage them.
Instructions
Front Turn Signal Bulb (21W)
Pull the assembly out of the vehicle and pull the top bulb holder out. Press the bulb in and rotate it to the left to remove it.12.
Remove the turn term meeting embrace from the engine compartment. Subsume a Phillip screwdriver all the road into the gap that is revealed by removing the meeting and involve and loosen the screw inside by rotating it counterclockwise.
3. Pull the turn word meeting slightly absent of the vehicle, decent Sufficiently to arrive the bulbs at the rear. Proceeds and remove the bulb holder.
4. Press gently on the bulb and turn it to the left to remove it. Install the contemporary bulb by turning it to the exactly to lock it. Country the bulb holder back into the meeting and situate the meeting back into the vehicle.
5. Retighten the screw to secure the meeting and rapid the hood.
Side Turn Signal Bulb (5W)
6. Turn the 740iL's engine off. Place on gloves and open the hood.
7. Use a screwdriver to pry out the lamp at the rear edge. Apply gentle pressure to the bulb while turning it to the left to remove it.
8. Install the new bulb by turning it to the right to secure it. Push the lamp back into its initial position and close the hood.
Rear Turn Signal Bulb (21W)
9. Turn the 740iL's engine off. Put on gloves and open the trunk.
10. Remove the liner from the edge of the trunk to disclose the two securing screws. Remove the two securing screws with a Phillips screwdriver.
11.1. Turn the 740iL's engine off. Place on gloves and regulate the hood.2.
Install a replacement bulb by pushing in the new bulb and rotating it to the right. Place the assembly back into the vehicle and reinstall the two securing screws.
13. Reattach the liner and close the trunk.
