Installing a wood Bedstead in a classic Chevy is a quite manageable restoration project.
Chevy trucks are an American likeness. One attribute of classic trucks that has been done absent with in their virgin counterparts is the wooden Bedstead floor. The graceful detailing in a chrome and wood floor is a colossal finishing touch for a 72 Chevy. Nearly fourty dotage next machine and Motor lorry restoration has be reformed ample Sufficiently craft for reproduction Bedstead replacement kits to be a eagerly available commodity, short-cutting the wood employment.
Instructions
Fleet Side Chevy
Pull them out on the top side with pliers and pry the old boards from the bed with a flat pry bar.7. Install the round cut short pieces in the four corners of the bed first, to fit around the wheel hubs, two pieces in each corner. Fit the first long piece with its cutout fitted neatly against the hub on each side of the truck bed. Tap the bolts up buttoned up the wood with a hammer and pull them elsewhere the top side with pliers. Lift the bolt strips and pry the antiquated wood up with a Apartment lodgings pry bar.
2. Chop the two gone boards with a hammer and chisel, driving the chisel down on ice the boards along the angle iron strip at the side of the Bedstead. The bolts in 1967 and newer Chevy trucks along the angle strips are welded in and are best kind left in lay. Chip the remaining wood from underneath the angle with the chisel and hammer.
3. Match up the fresh elsewhere wood strips with the metal angle strips and objective the locations of the bolts. Score the side strips to fit encompassing the bolts with a jig epigram, notching in Everyone direction ¼ inch Broad and 1 inch from the line of the board. Slide the line boards under the angle strips.
4. Position the remaining boards across the Bedstead, tight up against the back of the cab. Operate the broadness of board in Everyone location that matches up to the bolt spacing. Align the chrome bolt strips between the wood boards, fitting the turned down edges into the grooves in the board edges.
5. Drop new bolts down through the chrome bolt strips and run a washer and nut up onto each from underneath the truck. Use the impact gun to tighten them up.
Step Side Chevy
6. Remove the original boards. Loosen and remove the nuts from each bolt and tap them up through the boards.1. Remove the ancient Bedstead wood. Loosen the nuts on the bolt strips underneath the Motor lorry with an results gun.
8. Position the remaining bed boards to fit with the bolt patterns in the bed. Fit the chrome bolt strips between the boards, fitting the down turned edges of the chrome strips into the grooves in the edges of the board.
9. Install new bolts through each hole in the chrome bolt strips. Thread a washer and nut onto each bolt and tighten each by hand. Tighten the nuts remainder of the way and snug them down with the impact gun. Be careful not to over tighten, to prevent dimpling the chrome strips.
