The Chrysler Town & Native land little comes equipped with rear CD brakes. Install the new inboard brake pads followed by the outboard brake pads.7. Lower the caliper back into position over the rotor.
Applicability a syringe or suction gun to siphon 1/3 to 2/3 of the brake fluid from the crackerjack cylinder reservoir. Empty it into an approved sealed container and properly dispose of it according to your governance's principle.
2. Up thrust the rear of the Chrysler Town & Homeland from the ground with a machine jack. Device the machine on all sides with jack stands and cache children elsewhere of the vicinity when you change the rear CD brakes.
3. Loosen the lug nuts of the rotate assemblies with a torque wrench. Remove the circle and tire assemblies and place them aside face up to prevent damage.
4. Remove the two caliper handle pin bolts. Rotate the top belongings of the caliper away from side of the brake rotor and secure it to the frame of the Town & Country with mechanical wire. Pry the outboard brake pad out of the caliper.
5. Compress the piston into the bore with a large C-clamp to prevent damage to it when removing the inboard brake pads. Pull the inboard brake pad away from the piston until the retainer clip pops free of the piston cavity.
6. Grease the caliper mating surface and the abutment surfaces with a brake grease. Cover the back of the new inboard and outboard brake pads with an anti-squeal lubricant. The rare vans that retain them were normally modified after obtain. Whether your Chrysler Town & Homeland has rear CD brakes, peruse as well to memorize convert them in a couple of hours or less.
Instructions
1.Install the guide pin bolts and torque to 17 foot/pound. Replace the wheels and torque the lug nuts to 100 foot/pound. Lower the Chrysler Town & Country to the ground.
