A six-point wrench Testament prevent you from stripping bolts and nuts.
Tighten the alternator bracket top mounting bolt using the ratchet and socket.17.Tighten the alternator lower mounting bolt by holding the bolt with the back up wrench as you tighten the retaining devotee with the ratchet and socket.18.
Instructions
Removing the Alternator
1. Disconnect the absent (brunet) battery cable using a wrench.
23. Connect the abrogating (charcoal) battery cable using the wrench.
3. Unfasten and remove the dipstick tube mounting bolt using a ratchet, ratchet interval and socket.
4. Pull the dipstick tube from the engine.
5. Unplug the wiring harness connector from the back of the alternator.
6. Detach the wire from the back of the alternator using a wrench.
7. Loosen the alternator lower mounting bolt. Dominion the bolt with a back up wrench as you loosen the bolt retaining devotee with a ratchet and socket.
8. Loosen the alternator bracket top mounting bolt using the ratchet and socket.
9. Stop removing the alternator lower bolt, retaining aficionado and washer.
10. Stop removing the alternator bracket mounting bolt. Then remove the alternator from the engine compartment.
11. Detach the bracket from the alternator using the ratchet and socket.
Installing the alternator
12. Attach the bracket to the fashionable alternator however act not tighten the mounting bolt still.
13. Fix the contemporary alternator and bracket in position in the engine. Then install the bracket mounting bolt finger tight.
14. Install the alternator lower mounting bolt, washer and retaining fan finger tight.
15. Tighten the alternator to bracket mounting bolt using the ratchet and socket.
16.The alternator on your 1997 Mitsubishi Diamante is held in compass by two mounting bolts and a mounting bracket. You may pride it easier to remove the alternator and bracket to install the fashionable unit. But, cause undeniable of the succession of any mounting hardware if for your alternator other than the bolts. This Testament comfort grasp the replacement unit undeniable in accommodation and prevent the bolts from future loose by the engine vibration during course.
Attach the wire to the back of the alternator using the wrench.
19. Plug the wiring harness to the back of the alternator.
20. Install the dipstick tube on the engine.
21. Install and tighten the dipstick tube mounting bolt using the ratchet, ratchet margin and socket.
22. Install the impel girth by tightening the tension pulley adjusting bolt to supply the Correct region tension using the ratchet and socket. Then tighten the tension pulley centre bolt using the six-point box boundary wrench.
2. Remove the ride cummerbund by loosening the tension pulley centre bolt with a six-point box extreme wrench. Then loosen the tension pulley adjusting bolt using a ratchet and socket.
