Brake pads are the replaceable friction pads that pinch the brake CD when you transaction on the brake pedal.3. Elevate the rear extreme of your Corvette with your machine jack. Remove the rear tire or turn meeting.4.
1. Lawns your motorcar on a consistent surface. Establish the parking brake. Domicile blocks in front of the front tires so the automobile does not action while you are working on it.
2. Plain the hood of your automobile and disconnect the con battery cable.
They are an exigent articulation of your Chevy Corvette's braking step. You should alternate the brake pads before they wear beyond a 1/4 inch, or risk defective your Impala's brake discs.
Instructions
Remove the Rear Brake Pads
District a blimp C-clamp on the target of the caliper. Accommodation the clamp ends against the rear of the caliper entity and the outboard pad. Slowly tighten the clamp evenly to compress the pistons.
5. Remove the upper caliper bolt and fulcrum the caliper downwards until you annex Sufficiently clearance to remove the brake pads. Collar the caliper with wire or a petite bungee cord.
6. Take the brake pads and lining assemblies out of the caliper.
Install the Rear Brake Pads
7. Use a brake parts cleaner to remove all residue from the pad and lining assembly guiding surfaces on the caliper housing and the mounting bracket. Make sure the caliper pistons are fully compressed.
8. Place the outboard pad and insulator in the caliper housing. Place the inboard pad with the wear sensor into the caliper pistons. Firmly press the pads until they are they are fully seated.
9. Pivot the caliper upwards until it stops. Insert and tighten the upper bolt to 23 foot pounds. (31 Nm).
10. Replace the wheel assembly (tire). Lower the car to the ground.
11. Reconnect the negative battery cable.
