Aftermarket hitches can add the VW Eos with a towing authority up to 1,000 pounds.
The Volkswagen Eos is a hardtop convertible that provides seating for up to four passengers. No authorized towing authority is if by Volkswagen for the Eos, nevertheless an aftermarket Congregation I hitch from Curt Manufacturing provides at owing force of up to 1,000 pounds. The Crowd I hitch requires alterations to the trim under the rear bumper for Correct adoption.5. Trim the wings of the heat shield, using the aviation shears, to create a square shape.6. Reinstall the heat shield with the original hardware removed during Step 4.
Remove the rubber isolators. Using an exhaust hanger Emigration factor, you can pry the isolators for nothing. The rubber isolators are on the Chauffeur's side and centre of the Eos.
2. Remove the two bolts securing the side exhaust bracket on the passenger side. Avail the sockets and ratchet to loosen the bolts.
3. Lower the exhaust. The exhaust system Testament be loose and compulsion to be lowered to the ground by help.
4. Remove the exhaust operation's heat shield. Using the ratchet and sockets loosen the bolts securing the heat shield. Once the bolts are removed the heat shield can be removed.
You can close this Homewards by next these directions.
Instructions
1.7. Fish-wire the carriage bolts and spacers through the frames access hole to the holes found in the rear-most section of the frame.
8. Raise the hitch into position. On the passenger side, the exhaust bracket will mount against the side plate.
9. Hand-tighten the mounting hardware. The M8 Bolts will be attached to either the existing weld-nuts or half-inch flange nuts. It may be necessary to alter and cut the trim found under the rear fascia for proper fitment.
10. Tighten all the half-inch bolts and nuts used to install the hitch to 75 foot-pounds of torque with the torque wrench
11. Tighten all the M8 bolts to 17 foot-pounds of torque with the torque wrench.
12. Reinstall and secure the exhaust system.
