Modify the Starter on a 1998 Chevy Cavalier
The starter on a 1998 Chevy Cavalier is an electric Engine mounted to the engine block. When the Chauffeur turns the ignition, the starter Engine turns either the flywheel (instruction transmission) or the flex plate (automotive transmission), which in turn rotates the crankshaft. At the equivalent age, the distributor begins to conflagration the Glimmer plugs and fuel injectors spray fuel into the combustion chambers. When all three elements are working prerrogative, the engine can dart.
The starter motor on a 1998 Chevy Cavalier can be replaced by the vehicle owner, however as with any automotive repair, safety should be the fundamental precedence.
Instructions
Removing the Starter Motor
1. Unhook the adverse battery cable from the battery. Found by loosening the retaining bolt with a wrench. Then pull the clamp off the terminal.
2. Stand the front of the vehicle using an automotive jack. Then bed with jack stands placed underneath the front subframe.
3. Allot the starter. It Testament be bolted to the rear of the engine block, near where the engine meets the transmission.
4. Unscrew the two bolts that secure the starter Engine to the engine block, using a socket. Be trustworthy to brace the weight of the engine block with your share. Failure to complete so could strip the threads in the engine block.
8. Lower the starter away from the engine and slide it out from underneath the vehicle.
Installing the Starter
9.Label the wires connected to the starter solenoid using masking tape and a marker.
7. Disconnect the wires from the starter solenoid by unscrewing the nuts that secure them, with a socket. Then pull the wires off the solenoid.
5. Lower the starter motor away from the engine block, but do not allow the starter to hang from the wiring harness connected to the starter solenoid.6.
Lift the starter motor up underneath the engine block.
10. Slide the starter wires onto the starter solenoid, following the labels you made during disassembly. Then screw on the nuts that retain them, using a socket.
11. Lift the starter into position.
12. Screw in the bolts that secure the starter motor to the engine. Be sure to support the weight of the starter while screwing in the bolts. Failure to do so could strip the threads in the engine block.
13. Lower the vehicle.
14. Reconnect the ground cable to the negative battery terminal. Slide the clamp over the terminal. Then tighten the retaining bolt with a wrench.
