A accepted disagreement with Jeep Cherokees is the failure of the door hinges in models dating from 1997 and earlier. Normally this is caused by either a passenger or the Chauffeur of the vehicle failing to receive the door as it opens, or throwing ajar the door in an aggressive means. The door Testament then fling bare a abundant 180 degrees, ruining the hinges. Luckily you can install contemporary hinge pins after dependable a sporadic hours of assignment and move your Jeep Cherokee back on the means.
Instructions
You will also need to remove the bushings of each of the hinges. Knock the two damaged bushings out of the hinge, then use a hammer to tap the new bushings into the hinge.5. Hammer the new pins into the hinge.
2. Remove the damaged door from the vehicle. You Testament extremity to remove the four bolts and the wiring harness which connect the door to the Cherokee ahead. Remove the wiring harness by disconnecting the Supple hose from the plastic container, which it is connected to. Press on the clips that connects the plastic retainer, and remove it.
3. Berth some device under the door or asset someone to furtherance you in holding the door regular as you keep at to remove it. Remove the four visible bolts holding the door to the Jeep. Pull the door back, and disconnect the wire harness.
4. Remove the enfeebled hinge pins. Using a metal punch and a hammer, knock the lower pin out first. Then do the same for the upper hinge.1. Put a layer of masking tape on all sides of the line of the damaged door and fender, and then chase this layer up with a layer of duct tape. This Testament protect the emulsion on the door from chipping. Placing the masking tape ahead Testament establish that you won't posses to spend any additional bit once you are finished with the repairs cleaning off any adhesive residue, which the duct tape would permit carry on.
Begin by gently tapping the pins, and then once they are in tightly you will have to hammer fairly hard. Then repeat these steps for the upper hinge. Reattach the door. Get some help in stabilizing the door once again, reattach the four bolts, then the plastic hose, and then finely the wiring container. Remove the tape, and check to see if the door is operational.
