The 2002 Toyota Camry features a 3.0-liter V6 and besides a 2.4-liter four-cylinder engine. The V6 came with either rear drum or rear CD brakes very. The 2002 Camry is the sixth siring of the vehicle, which ran from 2001 wound up 2006. Owing to period frame, replacing the front or rear brake pads was universally standardized.
Instructions
1. Remove and discard half of the brake fluid from the Toyota Camry V6 crackerjack cylinder using a turkey baster. Alter the cap tightly.
2. Lift the Camry on a machine lift and then remove the hub caps (provided relevant) from the front or rear wheels--depending on which fix of pads you're replacing. Remove the lug nuts using the force gun and a 21 mm socket. Remove the wheels.
3. Practice a 14 mm wrench to remove the caliper mounting bolts. Remove the decrepit brake pads from the torque mount. Observe the brake rotor. Scored, grooved or severely rusted rotors should be considered for replacement. Contemporary pads Testament not rent in to compromised rotors fit.
Remove the caliper and then hang it from the suspension using a caliper hanger or hook. Compress the caliper piston into the caliper Muzzle using a C-clamp.4.
5. Disinfected the pad springs thoroughly using the dwarf wire brush. Exercise a coat of silicone brake grease the springs where the pad tabs Testament contact the springs. Lay the virgin wear indicators onto the current pads and the anti-squeal shims--some replacement pads may admit already riveted these components onto the pads. Install the different pads, forging firm that the arrow of the wear indicators is pointing in the order of the revolve rotation.
6. Position the caliper over the pads and rotor. Manipulate a glowing coat of silicone brake grease on the non-threaded chop of the caliper mounting bolts, affiliate the bolts into the caliper and then tighten them to 25 foot-pounds using a 14 mm socket and the torque wrench.
7. Exchange the wheels and lug nuts. Tighten the lug nuts to 80 foot-pounds using the torque wrench and then replace the hub caps (if applicable).
8. Repeat this procedure for the other side. Lower the Camry when finished. Pump the foot brake pedal to seat the new pads to the rotor, then check and adjust the level of brake fluid in the master cylinder. Test drive the Camry to ensure the pads are working properly and no noises are emitting from the brakes.
