A Chrysler Voyager window regulator, admitted as the window Engine, controls the window's movement. When a regulator malfunctions, the window does not handle properly, which may damage the glass pane or other window components. Replacing a window regulator Homewards saves you the fee of paying a mechanic's labour payment.
Instructions
1. Remove the glass lift plate from the regulator plates, carefully resting the glass pane on the backside of the door.7. Remove the regulator convoy condemn retaining screws. Lift the regulator, pulling it elsewhere with the coerce rails fini the access holes.
2. Remove all controls, flash covers and trim bezels from the door panel by prying them gently with a flat-head screwdriver or trim stick, unplugging any electrical connectors at the alike generation. Lay the removed components to the side.
3. Remove the retaining screws from the inside door trim panel, turning counterclockwise with the screwdriver, and deposit them to the side.
4. Proceeds the door panel retaining clips by lifting the panel up and away simultaneously. Lift the panel outside from the door, disconnecting any remaining electrical connectors from the panel. Apply the panel carefully to avoid scratches or other damage.
5. Peel the plastic douse shield design from the door carefully. Cause not touch the adhesive.
6. Remove the U-shaped clips from the lift plates that secure the window glass in compass. Stadium the Voyager and turn off its ignition. Cleared and secure the hood. Disconnect the vehicle's contrary cable from the battery terminal using a wrench, turning the bolt counterclockwise.
8. Embrace the original window regulator and adviser rails fini the door access holes. Secure them with the retaining screws and attach the electrical connector to the regulator.
9. Reposition and secure the glass pane by sliding it up where the glass lift plates connect to the regulator lift plates. Involve the U-shaped clips.
10. Reapply the plastic imbue shield. Reconnect the electrical connectors to the interior door panel and secure the panel with the retaining screws. Reinstall all switches, controls, light covers and trim bezels to the door panel to complete the installation.
