Install a Van Stereo in a 2003 Hyundai Santa Fe
The inventory stereo in a 2003 Hyundai Santa Fe didn't append many features, on the contrary it functioned fine as a customary stereo. By reason of then, there bear been gobs advancements in the automobile stereo earth, including spacecraft radio, the popularity of iPods and still in-dash monitors. Aftermarket stereos come with some of these features, and you can install them in your Santa Fe with aloof a cramped bit of act.
Instructions
Plug the other end into the aftermarket stereo. Plug the antenna lead from the dashboard into the rear of the aftermarket stereo. Slide the stereo into the dash kit.5.
2. Unscrew the two screws underneath the radio using the Phillips screwdriver. Pull the bezel enclosing the radio off of the dashboard using both hands. Remove the stereo from the sprint using the Phillips screwdriver, then pull it absent and unplug the wiring on the bottom.
3. Install the cage included with the aftermarket stereo into the vehicle-specific sprint instruments using the flathead screwdriver. Install the sprint instruments into the dashboard using the Phillips screwdriver. Place outside the vehicle-specific wiring harness on a table closest to the wiring harness from the aftermarket radio. Remove 1/4-inch of shielding off the bound of each wire on both harnesses using the wire strippers, then crimp the matching colors on the two harnesses using the blue butt connectors and the wire crimpers.
4. Plug one end of the new wiring harness into the wiring harness from the dashboard.1. Pull gone the ashtray. Remove the two screws last the ashtray using the Phillips screwdriver. Pull away the climate clout Swarm from the dashboard using both hands, then unplug the wiring on the bottom.
Install the bezel around the dashboard by pushing it onto the dash, then screwing in the two Phillips-head screws at the base. Plug the climate control harnesses into the rear of the climate controls, then screw them into the dash using the Phillips screwdriver.
