Friday, March 13, 2015

Switch The Cruise Control Turn On A Ford

Ford has offered vehicles with steering wheel-mounted cruise state buttons thanks to the 1960s. This allows drivers to allot and adjust the cruise governance without bewitching their eyes off the plan. Cruise bridle can save fuel milage by concern the vehicle at a fixed precipitation. The cruise authority is operated by a switch carry on the horn pad and airbag on the steering revolve. The switch Testament probably require replacement whether the cruise clout in your Ford vehicle is malfunctioning.


Remove the switches from the steering turn meeting.5. Install the contemporary cruise driver's seat switches in the steering wheel assembly by tightening the attaching screws with a Philips screwdriver. Plug the wiring harness connectors into the switches.


Pull the cable off using a twisting moving. Wait 15 minutes before continuing, to insure ongoing has been completely shut off to the airbag.


2. Pry off the two plastic plugs on the back of the steering shove spokes with a tiny flat-blade screwdriver. Applicability control not to scratch the plastic. Remove the two bolts revealed after removing the plastic plugs with an 8mm socket attached to a 1/4-inch propel ratchet.


3. Carefully lift up on the horn pad/air bag module and disconnect the wiring harness from underneath the module. Establish the module aside.


4. Loosen and remove the cruise state switch attaching screws (located under the horn pad/air bag module) with a Phillips screwdriver. Remove the wiring harnesses from the switches (there are two) by pulling the connectors elsewhere by ability.

Instructions

1. Yawning the hood of the vehicle. Remove the anti battery terminal by loosening the clamp with an adjustable wrench.



6. Place the horn pad/air bag module onto the steering wheel and replace the two 8mm bolts through the holes in the back of the steering wheel spokes. Tighten the bolts with an 8mm socket attached to a 1/4-inch drive ratchet.


7. Push the negative battery cable back onto the negative battery terminal and tighten the nut with an adjustable wrench. Close the hood.