Installing a vehivle alarm on the Dodge Ram Motor lorry requires appreciable consciousness of automobile electronics for a Correct installation. The 2009 mannequin Dodge Ram uses a wiring method that controls all of the trucks features and engine finished a unmarried news wire and crackerjack installation is required. Earlier model Dodge Ram trucks application principles wiring and approximately two hours to install.
Instructions
1. Scan the alarm volume carefully and arrange you hold a clarion discerning of the connexion methods the manufacturer recommends. Direct the hood and remove the positive battery cable from the terminal. Connect the alarm faculty wire to the positive battery cable and pull the wire to the Chauffeur's side of the firewall.
2. Mount the alarm siren in an expanded sphere of the engine bay, facing the engine to edge soak exposure when driving. Run the wires to firewall and feed all of the wires into the cabin through the existing hole directly in front of the steering wheel.
3. Connect all of the wires to the alarm control module. Mount the control module as far into the Dodge Ram's dash as possible with zip ties. Reconnect the positive battery cable and test the alarm. Adjust the alarm sensitivity and secure any loose wires.
Drill a small hole in the dash or center console for the LED light and snap it into place. Identify the starter wire in the ignition harness behind the steering wheel and attach the start disable relay.
5. Install the shock sensor per the manufacturer's instructions and run the wire to a central point under the dash. Connect the power lock module to the lock relay near the fuse box if the truck is equipped.4.
