Installing an machine sunroof can be a do-it-yourself duty. It is exigent that you shop for the particular sunroof utensils designated for your van's constitute and representation. You can get a instruments online or at a native Car parts retailer. Most kits Testament come equipped with the frame, the glass, the inserts, a fix of screws and maybe a roll of weather stripping and caulk. Once you chalk up your implements, mention to its establish directions to avoid costly mistakes and to bring about the installation method as efficient as credible.
Instructions
1. Arena the vehicle on even ground absent from traffic. Turn off the engine and disconnect the battery. Situate tarp or protective covering over the motorcar's interior seats.
2. Point the nature where the sunroof Testament be positioned with a non-permanent good aim marker. To catch the true position, rearrange the front seats to their rear-most position on their tracks. Straighten the rear-most line of the sunroof with the seat's back.
4. Select the appropriate bits to use on the electric hand drill. Use the drill to begin a hole in the rear edge of the sunroof so that it is in line with your markings.
3. Tape the paper template found in the sunroof kit atop the roof of your vehicle. Center the template between the sides of the car's roof, making sure that the rear frame is aligned with the seat's backs. Mark over the template's installation lines with the marker.
5. Use an electric hand saw with a sheet metal cutting blade to chop along the template's installation markings starting from the drill hole. Use slow and precise strokes to reduce error as you cut. Remove and discard of the cut-out metal.
6. Use a razor blade or utility knife to chop out the headliner along the installation line markings. Refrain from cutting through all of the headliner straightaway. According to Guide 365, "the inner frame will cover the cut edge once the sunroof is installed."
7. Install the sunroof frames from the kit. Test fit them first -- both inner and outer -- so that they position in the hole properly. Adjust the hole by sawing out more metal until the frame sits squarely and flat inside the opening.
8. Apply the gasket seal around the border of the opening as directed in the kit instructions.
9. Test-install the sunroof's outer glass so that its border is positioned snugly around the gasket seal. If you notice a gap, fill it in with weatherstripping caulk. Remove the glass and frame.
10. Fill all large gaps with weatherstripping and caulking, and then reinstall the frame and glass. Insert and secure all screws that came with the kit. Clean away all caulk residue with a rag and mild soap.
