Moderate the Brakes on a 2003 Chevy Z71
Replacing the brake pads on the Chevy Z71 is corresponding to the manner on most trucks. The one variations would be provided the Motor lorry is not a 4x4. The brake pads are mounted against the surface of the rotor. When the brake pedal is depressed, impulse is applied to the pad by the calipers and the skilled cylinder, urgent the pad against the rotor, slowing or stopping the Motor lorry. Changing the brake pads at the ethical interval Testament amass the rotors and other parts from enervating absent before their age.
Instructions
1. Act the Z71 to calm ground and lay the transmission in lawns. Exercise the parking brake. Stand the hood.
2. Loosen the lug nuts on both front tires with the lug wrench. The lug wrench is a belongings that comes with your vehicle and is normally institute latest the seat. Turn the lug nuts in a counterclockwise rotation to loosen them.
3. Install the floor jack in front of the Motor lorry. Catch the centre cross member of the frame directly in borderline with the front wheels and distance the jack on the cross member. Jack up the Motor lorry until the front tires are even-handed off the ground.
4. Obtain the two safety jack stands and install them on the frame dependable persist the trundle on both sides of the Motor lorry. Adjust them to the Correct heighth and insure they are locked. Lower the Motor lorry onto the stands and go-ahead the jack under the frame along with the jack stands.
Handle the pry bar to pry the brake caliper piston back. This Testament permit you to remove the brake pads. Install the Apartment lodgings gratuity of the pry bar between the brake pad and the rotor, then pry the pads elsewhere from the rotor.7.
5. Remove the lug nuts from one of the wheels and situate the trundle to the side.6.
Remove the brake pins that are located at both ends of the brake pads with the pliers. Remove the brake pads and Disinfected the surface of the rotor. Install the C-clamp on the caliper piston and remove the top off the master cylinder, which is located under the hood on the firewall. Turn the C-clamp until the piston is fully retracted. Remove the C-clamp.
8. Install the new brake pads, aligning the grooves on the pads with the locking pin holes. Install the locking pins. Mount the wheel on the studs and install the lug nuts and tighten them in a clockwise direction until they are snug.
9. Repeat the process for each wheel. When finished, remove the jack and safety jack stands. Tighten all the lug nuts in a cross pattern on each wheel until tight. This will insure that the wheel is secure. Be sure the brake fluid reservoir on the master cylinder is filled to the proper level as indicated on the side of the reservoir. Put the top back on the master cylinder. Close the hood and pump the brakes several times before moving the truck.
