The 1993 Toyota Camry replica base came with the 2.2-Liter In-line four-cylinder 5S-FE engine. The exhaust manifold is attached to the cylinder tendency and routes toward the backside of the engine, where it connects to the exhaust down tube. There are no definite tools required to remove the manifold; but, the six manifold mounting nuts, exhaust manifold gasket and exhaust channel gasket all committal to be replaced when installing the exhaust manifold to the engine and exhaust down tube.
Instructions
Removal
Lower the vehicle until it rests securely on the jack stands.2. Calumny down under the vehicle. Unplug the O2 sensor wire harness from the O2 sensor by squeezing on the plug and pulling it except the O2 sensor pigtail without pulling on the wires.1. Exposed the vehicle hood and cooperate it with the hood prop rod. Lift the vehicle into the air with the floor jack. Put jack stands under the front frame rails of the vehicle.
3. Remove the nuts and bolts holding the exhaust manifold to the exhaust down drainpipe with the socket and ratchet. Remove the exhaust drainpipe gasket and dispose of it.
4. Remove the the six bolts that clutch the upper heat shield to the exhaust manifold. Remove the heat shield. Remove the exhaust manifold mounting nuts with the socket and ratchet and ratchet extent. Remove both exhaust manifold stays with the socket and ratchet. Remove the bolts securing the lower heat shield to the exhaust manifold with the socket and ratchet. Pull the exhaust manifold from the engine and discard the engine-to-manifold gasket.
Installation
5. Remove any leftover gasket data from the cylinder purpose and exhaust manifold with the gasket remover and razor blade, whether chief. Locate the cutting edge exhaust manifold gasket over the manifold mounting studs on the cylinder sense.
6. Establish the exhaust manifold onto the mounting studs on the cylinder purpose. Participation tighten the recent mounting nuts to benefit clutch the manifold in dwelling. Install the lower heat shield mounting bolts and tighten with the socket and ratchet.
7. Establish both manifold stays into corner and artisan tighten the seed a bolt. Tighten the fan and bolt for Everyone stay to 31 foot-pounds of torque with a torque wrench.
8. Defamation under the vehicle. Locate a just out exhaust cylinder gasket onto the exhaust cylinder and attach the exhaust main to the exhaust manifold. Tighten the mounting nuts to 46 foot-pounds of torque with a torque wrench. Plug the oxygen sensor wiring harness into the oxygen sensor pigtail.
9. Tighten the exhaust manifold to cylinder head mounting nuts to 36 foot-pounds of torque with a torque wrench. Set the exhaust manifold upper heat shield into place and tighten the bolts with the a ratchet.
10. Shut the vehicle hood. Lift the vehicle off the jack stands with the floor jack. Remove the jack stands and lower the vehicle to the ground.
