Tuesday, March 10, 2015

Install Stainless Brake Lines

Braided steel brake lines are a public performance upgrade on cars and trucks. Drain any excess brake fluid that spills out of the brake line into a suitable container. Spray brake cleaner onto the fittings where the brake lines install and wipe everything down thoroughly with a clean rag before installing the new braided steel brake lines. Install the braided lines in the same manner as the rubber lines. Tighten the fittings that hold the soft brake lines to the hard lines.


Instructions


1. Manipulate a lug wrench or a socket and ratchet to loosen the lug bolts that fasten the wheels to the machine. Lift the vehicle with a floor jack and then lower it onto jack stands at all four corners. Stop removing the wheels and establish them away of the street.


2. Disinfected the brakes with brake cleaner and a Disinfected rag. Spray the cleaner onto the caliper and rotor, paying specific concern to the where the brake lines are bolted on. Brush everything down with the rag so no oil and dirt are manifest.


3. Spray penetrating lubricant onto the ancient brake lines where they bolt to the vehicle. Let the fluid soak in. This may not be decisive whether the vehicle is newer, on the other hand on older vehicles the brake line hardware may be frozen on.


4. Utilize a wrinkle wrench to loosen the Trimmings that bolt the rubber brake limit at either limitation to the automobile. A string wrench is a exceptional open-ended wrench that goes extremely encircling the seed and Testament aid prevent it from stripping. It should be relatively straightforward to establish where both ends of the soft brake contour install, on the other hand it may benefit To possess a workshop notebook for your vehicle. One location Testament fasten to the exhausting line that goes to the skillful cylinder and the other limitation Testament bang into the caliper or into a short compressed line that goes to the caliper. Once you have loosened the nut that holds the line in place, you should be able to loosen the fitting located on the end of the hard line that installs onto the brake line. The fitting is turned with a wrench to unthread it from the brake line.


5. Orderly rubber brake lines expand slightly when the brakes are applied, which can margin to spongy, less-than-firm brake pedal mood. Stainless steel braided brake lines eliminate this point with their metal interpretation, which prevents the brake wrinkle from expanding when brake fluid is suddenly pumped ended it. The creature is a firmer brake pedal and and prompt reactions when the brakes are applied. Make sure that there are no kinks or bends in the new brake lines and that the lines do not interfere with any suspension components or bodywork. Tighten the brake lines with a torque wrench according to the directions that came with the lines.


6. Bleed the brakes so that there is no air in the brake lines according to the manufacturer's procedure, which will vary depending on the make and model of car. Reinstall the wheels and lower the car back to the ground. Test drive the vehicle gently to make sure that there are no problems with the brake system.