Regular brake CD with caliper and brake pads meeting in assign
Before removing the inner brake pad, compress the caliper piston using a C-clamp to push it into its bore, then remove the inner brake pad by releasing the pad retaining clip from the caliper piston using a standard screwdriver.5. Clean the caliper and steering knuckle from brake lining dust. Use brake parts cleaner and a shop rag to remove the dust.
1. Grounds your machine in a unharmed domicile on a common surface and bare the hood. Remove the fill cap from the brake adept cylinder, mounted on the brake booster. The brake booster is the drum-like Element mounted on the firewall, Chauffeur side of the engine compartment. Using a fist pump, frame half of the brake fluid, and then modify the lid.
2. Loosen the spin lugs on both tires using a lug wrench. Up thrust the front of your vehicle with a floor jack and safely aid it on two jack stands.
3. Remove the tires and, starting at either spin meeting, remove the caliper mounting bolts using a ratchet and socket or Torx bit socket, depending on type of mounting bolts used on your specific vehicle.
4. Remove the caliper from the steering knuckle and brake disc. Using a standard screwdriver, disengage the outer brake pad from the caliper.When installing contemporary brake pads on your Chevrolet vehicle, it is a bully design to exchange the sets on both front circle assemblies at the alike generation. This Testament prevent brake pull as you manner on the pedal, caused by uneven pad wear. Once you corner the conscientious parts replacement for your specific mannequin, replace these steps for installation.
Instructions
If necessary, use a wire brush to scrape buildup off the wheel assembly and caliper. Also, clean the caliper mounting bolts.
6. Apply a light coat of anti-squeal lubricant to the mounting boards of the brake pads. Align the outer brake pad on the mounting base of the caliper, and slide the brake pad clips over the caliper, making sure the pad dowels fall into the caliper mounting holes.
7. Install the inner brake pad by pressing the back retaining clip into the caliper piston until the clip sits properly in place.
8. Set the caliper in place over the brake disc, aligning the caliper mounting holes with the mounting holes on the steering knuckle. Install and tighten the two caliper mounting bolts. Install the tire, and change the brake pads on the other wheel assembly following Steps 3 through 8. Lower the vehicle and finish tightening the wheel lugs.
9. Add new brake fluid to the master cylinder to bring the level to the full mark; depress the brake pedal several times to adjust the new brake pads to the disc rotor.
