Tuesday, December 9, 2014

Repair The Abs On The Pontiac Grand Prix

The ABS step on your Pontiac Grand Prix is a safety doodle that basically prevents your brakes from locking up under adverse driving conditions, compatible in the drizzle. Your ABS step is trumped-up up of four lone spin sensors near your wheels. Shove rush and other brake hookup relays from Everyone idiosyncratic sensor to your machine's Powertrain Check Module. Whether an ABS sensor goes damaging, you should transform rather than repair it.


3. Find the ABS sensor mounted on the inside of your wheel near the brake caliper. Remove its mounting bolt with your wrench set.4.



2. Park your Grand Prix on a flat surface and engage the emergency brake. Jack up the wheel you will be replacing the ABS sensor on and set your jack stand in place. Set your vehicle on the jack stand.


Instructions

1. Bring your van to an Car parts store and remit them to jog a unpaid diagnostic check to proclaim you which ABS sensor is elsewhere.


Lift the sensor and unplug the wiring harness plug from it. It will unplug by hand if you push in on the two plastic side tabs.


5. Plug the wiring plug into the back of your new replacement sensor.


6. Set your new sensor in place and insert the retaining bolt by hand. Tighten it by hand.


7. Jack up your Grand Prix a few inches, pull the jack stands out and then lower your Grand Prix down off the jack.