Installing a starter into a 1978 Chevy takes approximately an day.
Instructions
1. Disconnect the denying battery cable from the battery using a socket wrench. Stand the front of the vehicle to a comfortable heighth using a motorcar hoist or jack stands.
The starter measures 6 inches great and has a stupid metal Stop. The starter solenoid is attached to the starter. It provides the electrical in fashion from which the starter receives its ability.
Deposit blocks extreme the rear tires, provided using jack stands, to prevent vehicle movement.
2. Loosen the two leading starter nuts before putting the starter in field. Position the starter in the starter cooperate bracket, back borderline basic. Tighten the two leading starter benefit bolts using a socket wrench. Torque the two bolts to 25-35 ft-lb.
3. Remove the larger kernel from the starter solenoid and reconnect the wire. There are two wires hanging down from the top of the engine and Everyone has a colorful magnitude ring. The larger ring slides onto the larger starter solenoid connector, and the smaller ring slides onto the smaller connector. The two nuts have different size threads too, so only remove one nut at a time. Tighten the larger nut to 25-35 ft-lb.
4. Remove the smaller nut from the starter solenoid connector and slide it onto the smaller wire. Tighten the nut to 25-35 ft-lb.
5. Lower the Chevy to the ground and reconnect the negative battery cable using a socket wrench.
6. Start the Chevy up to make sure the new starter works properly.
