The inside rearview mirror on a Chevy Suburban is held on by defined glue called rear opinion mirror adhesive, which you can pay for at any parts store. This is the alone type of adhesive that works. Everything else likely has been tried and failed. This is inexpensive and, when used properly, Testament deliver plant results. The rearview mirror may come unglued from the windscreen for any numeral of reasons.
Instructions
1. Remove the Press-stud from the rearview mirror. There are two types of mirror buttons.3. Stop the windscreen spot where you Testament deposit the mirror. Avail the hoodoo marker on the out of the window, and deposit a atom in the centre of the Press-stud position, which you should be able to see with the adhesive present.4. The one with a Phillips screw is clear. Even-handed haul the screw gone and the Press-stud comes off.
2. Disinfected the Press-stud of all adhesive data using the razor blade. The side that is to be cleaned and that goes on the windscreen is the completely Apartment lodgings, smooth side. Disinfected the button with alcohol after scraping off all information.
One type uses a spring lock on the inside the mirror imitation that holds the Press-stud into the mirror model. The other type has an bright Phillips screw in the mirror base holding the Press-stud. Employment the petty screwdriver by inserting it into the humble slot in the mirror mould between the Press-stud and the example. This Testament unlock the spring and decent pull the Press-stud off.
Clean the adhesive off the windshield using the razor, and then rub the spot with a rag with alcohol to rid the area of adhesive remnants and dirt.
5. Take the cylindrical tube out of your rearview mirror kit. This is a plastic tube with a brush on the end. Squeeze the cardboard cover, and crush the plastic, which will release the fluid onto the brush. Remove the cardboard, and brush a square area under the location dot on the window. This is a primer for the adhesive. Allow this to dry for five minutes.
6. Cut the tip off the tube of adhesive that comes with the kit. Without touching the flat side of the button, place one spot of mirror adhesive glue on the flat, smooth side. Make sure the narrow rounded end is up, and line it up with the dot on the windshield. Do not push it over the dot. Hold pressure on the button for one minute before letting go.
7. Allow the glue to dry for two hours before installing the mirror. The kit may recommend only 15 minutes, but giving it extra time ensures the mirror will stick. Temperature and humidity can make a difference in how long the glue takes to cure.
