Avail spray-on or brush on distemper.
If you're restoring the Stop on a classic automobile or trying to receive outside the parking portion ding on a virgin van, you'll necessitate to duty with touch up colouring to place kid cosmetic damage. To possess properly blended touch up dye, you'll require to application the whitewash in the deserved transaction and buff the Stop afterward. This project is time-consuming and includes a plenty of drying chronology, so permit yourself a weekend to integral the effort.
Instructions
1. Compound 1 tbsp. of liquid dish soap with 1 gallon of feverish inundate.
2. Dip a tack cloth in the soap doctrine and wash the environment in extremity of touch up. Disinfected elsewhere all grit and grime, then rinse with douse.
3. Let the field dry naturally or towel dry it with a contemporary Hairpin cloth.
4. Scrutinize the directions on the back of your whitewash can or spray bottle to find the drying time you need to wait between coats. This varies by brand but will be listed on the back.
5. Open your can of touch up paint (if using) and dip a 2-inch paintbrush inside.
Or shake an aerosol can to confuse the paint, then remove the lid.
6. Apply one coat of paint to the affected area. Let the clearcoat dry the manufacturer's recommended time between each coat and again let the final coat dry overnight.11. Pour a quarter-sized amount of rubbing compound onto a tack cloth. Rub the compound over the area you painted, working it into the surface in concentric circles. Wait the recommended drying time.
7. Paint a second coat in the same manner. This time, paint a little bit into the area surrounding the affected area, approximately 1/2 to 1 inch on all sides. Again allow the paint to dry.
8. Add a third coat, expanding to 3 inches around the damaged area on all sides. By now you should not be able to see the damage.
9. Let the paint dry overnight, recommends Paint Scratch.
10. Prepare your touch-up clearcoat paint in the same manner, either by opening the can or by shaking the aerosol to distribute paint. Then apply three coats of clearcoat in the same manner as you applied the colored paint. Brush paint on in even strokes, working from side to side. Or spray paint on, holding the can 6 inches away from the car. Avoid spraying so much that you get drips since these will show in the finish.
Then wait until you see the compound develop a waxy haze.
12. Wipe off all traces of rubbing compound with a clean tack cloth. This removes the grit in the finish and restores the shine. Afterward, you should not be able to see any difference in your car's finish.
