The ignition operation starts with the solution and ends at the starter Engine.
The Chevrolet S-10 pickup Motor lorry uses an electric starter which, when it receives the electric pulse, Testament push a gear into the flywheel and beginning the flywheel to turn the crankshaft. When the starter Engine goes evil, it Testament not be able to push the flywheel. The S-10 offers effortless access to the starter so replacement should not booty further far-reaching to full-dress.
Instructions
1. Pull the hood Proceeds hasp under the steering circle. Unlatch the secondary hook under the hood. Lift the hood and prop up with the prop rod. Disconnect the battery to isolate the electrical influence.
2. Distance a jack under the front crossmember. Hoist the Motor lorry gigantic Sufficiently to assign jack stands under the frame rails on the Chauffeur and passenger side of the Chevrolet S-10. Lower the Motor lorry onto the jack stands.
3. Place the starter under the Motor lorry. Use the socket wrench to tighten the bolts.7. Unscrew the nut on the negative stud and place the negative lead on the stud.
Wrap a plenty of masking tape approximately it to make safe it is not flummoxed with the bad cable. Pull the colorless cable off the alike design. Complete not speck with masking tape.
5. Unbolt the starter by unbolting the three bolts holding it to the frame with the socket wrench. Place the three bolts to the side for later use. Pull the starter down from the frame. Place it in the box that the new starter was sold in. The old starter will have to be returned to receive your "core" charge.
6. Place the new starter up to the flywheel housing. Start the three bolts but do not tighten until all the bolts are started. The starter is located on the passenger side of the Motor lorry between the engine and the transmission.4. Unscrew the confident cable from the starter by unscrewing the petite aficionado holding it in put. Pull the cable off by the model.
Tighten the nut over the lead with a socket wrench to ensure the cable is secure.
8. Peel the masking tape off the positive lead. Unscrew the nut on the positive stud and place the lead on to the stud. Begin tightening the nut on to the stud by hand. Secure the nut with the socket wrench to ensure the nut is tight on the stud. Do not over-tighten as this could break the studs.
9. Raise the truck to remove the jack stands. Lower the truck to the ground once the jack stands are removed.
10. Connect the battery to restore the electrical power. Attempt to start the truck once the battery has been connected. The truck should start with very little hesitation.
