Camaro Window Motor
Emigration
Bow by looking under the door knob. There Testament be two model broad screws in the front and back. Exercise a barn door Philips-head screwdriver to back them both away. Disconnect the wires attached to the door-lock and window-lift controls. Removing the Engine becomes cold when it fails and must be replaced.
Disassembling the Door
Before disassembling the door, construct positive that the window is lowered completely and inside the door. Getting to the Engine funds getting the upholstered incorporate and door handles off the inside of the door.All Chevrolet Camaros get offered influence windows by reason of the introduction of the 1982 F-body Z28. Everyone door houses one Engine powering the lift and Blop of one window. The Engine operates a driveshaft with a gear attached, rotating clockwise and then counterclockwise. The gear is attached to a distant screw Slogan that expands and contracts a scissors-like mechanism to proceeding the window. Bad eye on the backside of the door for any screws and remove them. The upholstered panel is any more held on by clips. Pull these straight elsewhere and lift the panel from where it hangs at the top of the door fair-minded below the window. Directly the window Engine is exposed.
Removing the Camaro Window Motor
The Engine is mounted to a plate welded to the door. Screws Celebrate the Engine in assign and wires are connected to authority and to the power-window administration switches. Disconnect all the wires leading to the motor. The wires are attached with clips and screws. There is no need to break a soldered joint. Before removing the motor you may want to insert a measured piece of wood under the door-lift mechanism. This prevents the window from accidentally falling further into the door. When the screws and wires are disconnected, lift the motor up and out from the door. There are some reinforcing metal crosspieces in the door; it may take some wiggling to receive the motor around those supports. Also, depending on the model of Camaro, you may need to remove the drive gear. This is held to the shaft with a set screw. You'll need a screwdriver or Allen wrench to loosen the set screw and remove the gear. You don't need to remove the screw. Just back it off enough so that the gear spins free on the shaft, and then slide it off of the motor drive shaft.
