Amass the fuel action in your Chrysler Town and Native land in optimal instance by replacing the fuel filter every 30,000 to 40,000 miles. A Disinfected fuel filter funds Disinfected fuel injectors and a Disinfected fuel energy regulator. Pursue the directions below to alter the filter on a Chrysler Town & Territory in under 45 minutes.
Instructions
1. Benefit the fuel step force by removing the fuel pump relay from the authority distribution centre. Day one the engine and acquiesce it to dash until it stalls. Fling to begin it again and let it bound until it stalls. Start the engine of your Town & Country and check for leaks.
Disconnect the refusal battery cable and lift the vehicle. Support the fuel tank with a transmission jack. Locate the fuel filter on the top of your Chrysler Town & Country fuel tank.
3. Remove the fuel line from the front of the tank and then the ground strap. Next, remove the inboard side of the fuel tank straps and front T-strap fastener. Lower the tank about 6 inches.
4. Detach the fuel lines from the fuel pump module and then remove the fuel filter. Put the new filter in its place. Tighten the fuel filter bolts to 40 inch pounds.
5. Reconnect the fuel lines to the fuel pump module and reposition the tank. Replace the front T strap fastener and tighten it to 250 inch pounds. Put the inboard fuel tank straps back and tighten them to 40 foot pounds.
6. Put on the ground strap and connect the fuel line in the front of the tank. Repeat this procedure until it no longer Testament dawning. Turn the ignition off.2.
