It seems easy Sufficiently: push the pedal and the clutch Testament disengage, allowing you to shift gears.15. Reinstall any bolts or mounts that were removed to replace your car's clutch. Grab the transaxle, release the jack and lower your vehicle.16.
1. Verify that your vehicle's clutch is the source of your problems and not the pedal-arm bushings, activating cables or the slave-master cylinder.
2. Unhook the assured battery cable, the clutch cable or hydraulic slave cylinder to receive the transaxle ready for facile Emigration. Eliminate anything that may hinder your efforts, including exhaust pipes and the speedometer.
3. Secure your automobile in a sheltered position before jacking up the front mark.
4. Stabilize the engine with a jack below the oil pan. Remove the transaxle by undoing at least one engine mount.
5. Seperate the engine from the transaxle by removing the bolts that surround the flywheel phone housing.
6. Push the transaxle absent from the engine until the input shift clears the power plate.
7. Disengage the bolts surrounding the pressure plate and obtain it and the clutch CD outside. Evaluation to discern whether the flywheel's friction surface is scored, checked or has feverous spots. Remove, apparatus and reinstall the flywheel, whether needed.
8. Study the co-pilot bearing (bushing) located at the flywheel's centre to be confident the thorn bearings are lubricated and that there's no irritating. Very glad eye for any oil leaking enclosing the rear leading engine seal.
Replace the Clutch
9. Pursue the directions for replacing your machine's clutch carefully to avoid having to remove the transaxle.
10. Probation that the transaxle's input shaft isn't leaking; interchange if needed.
11. Take out the flywheel and the old seal and install a new seal.
Install a New Clutch
12. Clean the crankshaft flange before putting in the flywheel. With the flywheel on top of the flange, secure the bolts in a star formation to the specified torque for your vehicle.
13. Install the clutch disc and pressure plate. Prior to putting in the transaxle, attach the new release bearing to the release fork. The fork should move freely.
14. Hoist the transaxle into position and move it forward until the input shaft glides into the clutch disc's spindled hole. Do not apply force.
Provided your clutch isn't working properly, nevertheless, you'll hear grinding noises telling you it's hour for a just out clutch. Provided you don't hope for to obtain your automobile to a garage, postdate these steps to alter your automobile's clutch yourself.
Instructions
Remove the Old Clutch
Consider replacing your car's clutch cable. If you don't replace the cable at least adjust it for the right amount of free-play.
17.Confirm that your clutch's self-adjusting action is performing correctly by depressing the slave cylinder's piston into its bore.
18. Drive your car to be sure your clutch is working properly.
