The 1987 Toyota pickup has a starter Engine on the Chauffeur's side of the engine. The starter on these trucks is a compact unit and mounts to the phone housing of the transmission. Provided you suspect there is a poser with the starter on your Motor lorry, you can remove it and accept it bench tested at most Car parts stores. Most of the better retail parts stores Testament confirmation provided unpaid provided you bring the starter in.
Instructions
1. Disconnect the con battery cable from the battery terminal using a wrench to loosen the retaining bolt. Lift the cable stop off the terminal and isolate it from the battery.
Depress the locking tab on the second connector and pull it out of the connector on the starter. Do not pull on the wires when you remove the plug or you may damage them. Lay the wires and connector aside.5.
Allot the two wiring harness connections on the rear of the starter. Remove the retaining peanut from the "B" terminal with a wrench; this is the terminal with the barn door cherry wire on the stud type connector. Slide the wire off the stud and lay it aside.
4.2. Stand the front of your Toyota Motor lorry with a jack and bed it on a establish of jack stands. Be definite to grounds the Motor lorry on a flat spot with undeniable ground under the Motor lorry so the jack stands to sinks or leans while the Motor lorry is on them.3.
Locate the two mounting bolts on the front of the starter where it meets the bell housing. The bolts run through the bell housing and thread into the starter from the transmission side. Remove both the upper and lower mounting bolts with a socket and ratchet while supporting the starter motor.
6. Lower the starter motor out of the engine compartment then remove it from under there truck.
