Alter a Grand Cherokee Cat Back Exhaust
Slide the exhaust drainpipe and muffler absent from under the Jeep as a unit and discard. Position the latest exhaust course into place under the Jeep and lift it up, sliding the tail pipe over the top of the rear axle.6. Slide the new muffler onto the pipe at the back of the catalytic converter, making sure it is completely on the pipe.
Instructions
1. Up thrust the Jeep off the ground using a jack and facilitate the Jeep on all four corners with a place of jack stands. Be certain you are working on consistent, solid ground, before raising the Jeep, to prevent the jack stands or the Jeep from Stirring while you are working under it.
2. Establish the rubber hanger that supports the tail conduit remain the rear axle. Push the pin on the tail pipe gone of the hanger and let the tail cylinder hang down.
3. Procedure up to the muffler and place the Seam between the catalytic converter and the muffler. It Testament acquire an exhaust clamp holding the two pipes calm.
4. Loosen the bolt on the exhaust clamp with a wrench or socket and ratchet and slide the two pipes apart. They may not come apart easily, so wiggle or turn the muffler to benefit cuffo the channel.
5.Replacing the all-inclusive exhaust, from the catalytic converter to the tail drainpipe, on the Jeep Grand Cherokee can be done in a hardly any elementary steps. The action can be changed to add a performance exhaust or to even-handed moderate a damaged or rusted exhaust course. The catalytic converter does not demand to be changed unless it is damaged or provided you are enticed in adding a eminent flow catalytic converter on the Jeep. There are many at variance systems gone there that Testament add performance, durability and longevity to your exhaust process.
If you do not get it all the way into place, the rear hanger will not line up.
7. Lift the tail pipe up and slide the pin on the tail pipe into the rubber exhaust hanger. Move forward and install a new exhaust clamp on the pipe that connects the catalytic converter to the muffler.
8. Tighten the nuts on the clamp with a wrench or socket and ratchet. Remove the jack stands from under the Jeep and lower the Jeep to the ground with your jack.
