Aligning the door to the Buick's item and door jamb is one of the most colloquial door repairs.
Accepted Motors presented the Buick Century to the American automotive consumer in 1936. The Century was debuted as a full-size performance vehicle. The Century was manufactured continuously wrapped up 2005, apart from for a 12-year space from 1942 over 1954. In 1973, the Century was redesigned as a mid-sized sedan. Buick has remained one of G.M.'s top revenue-producing lines. The majority of door repairs on a Century revolve sorrounding adjusting the alignment of the door in the vehicle's door doorpost. This is normally due to habitual wear and tear on the vehicle. The door alignment can be adjusted with average tools and basic automotive repair comprehension.
Instructions
1. Disconnect the cynical battery cable from the vehicle's battery.
2. Exposed the door that needs repaired or adjusted.
3. Set the upper and lower hinges on the door activity serviced.
4. City a aim with a grease pencil on the upper and lower door hinges where the vehicle door meets the hinge. This Testament objective the starting habituation position of the door.
5. Place the door-lock striker pin on the vehicle's door post. The striker pin can be commence nearly up on the non-hinged door jamb. Remove the striker pin using a socket wrench and socket. Set the striker pin aside. Removing the striker pin allows the door to swing free and makes adjusting the door easier.
6. Close the vehicle door and check the inner, outer, upper and lower alignment with the door jamb's and vehicle's body panels. Locate and mark any misalignment with a grease pencil.
7. Open the vehicle door.
8. Place a floor jack under the bottom edge of the door. Raise the floor jack until the weight of the door is supported by the jack.
9. Loosen the three "hinge-to-door" retaining bolts on the upper and lower hinges using an open-end wrench.
10.16. Connect the negative battery cable to the vehicle's battery.
Close the door to check the door alignment. Repeat the above steps to further correct any alignment problems.
13. Torque the "hinge-to-door" bolts to the manufacture's recommended torque level using a torque wrench.
14. Install the door-lock striker pin on the vehicle's door jamb using a socket wrench and socket. Make sure the striker pin is evenly seated on the door jamb.
15. Remove the floor jack from under the door assembly. Shut the vehicle's door and make sure the door is latching on the striker pin.
Move the vehicle door up or down, backward or forward to correct the door alignment.11. Tighten the "hinge-to-door" bolts using an open-end wrench.12.
