Moderate a Side Design Mirror
Although the mirrors attached to the side of your vehicle may not contemplate fair close every other private or import vehicle, the manner the manufacturer used is the alike. The mirror housing has three studs that extend completed the adequate door and bolt into deposit with three nuts located extreme an access panel on the inside of the door. The formation of replacing a side look mirror is relatively straightforward.
Instructions
1. Allot the access panel on the inside of the door. The panel is located directly contrapositive where the mirror bolts drive down the elsewhere of the door. Pull the include off the inner door panel with your hands.
2. Pull the wiring harness for the mirror's Engine elsewhere from last the access panel so you can drudgery with it. Pull the two ends of the connectors apart to disconnect the mirror's Engine from the vehicle's electrical manner. Not all mirrors keep motors. Whether you adjust your mirror manually, skip this development.
3. Remove the three nuts that secure the mirror with a ratchet and socket. Control the mirror or get someone grasp the mirror while you remove the nuts.
4.6. Push the two wire connectors together and tuck the harness back into the sub-frame of the door. If your mirror is adjusted manually, skip this step.
Pull the mirror out of the door and then place the studs of the new mirror through the door.5. Thread the nuts onto the studs with your fingers to avoid cross-threading, and then tighten the bolts with the socket and ratchet.
7. Place the access panel back onto the door, line up the small tabs on the back of the panel with the holes in the inner door panel and push on the access panel with your hand to lock it in place.
