Over lifetime, your vehicle's brake lines may develop into damaged or corroded. When this happens you should repair the lines by replacing them with aggrandized trustworthy steel brake lines. Once you've hell bent your brake lines itch to be replaced you can bring about the berth in your garage, saving you a bundle over having them replaced at an Car shop. Nevertheless, it's extensive that you alter them as soon as credible as driving with leaking brake lines poses a extensive safety hazard.
Instructions
Refill the master cylinder after replacing and bleeding the other brake lines. Lower your vehicle from the support stands. While it's not bottom line to achieve so, removing Everyone revolve Testament constitute it easier to arrive the damaged brake column.
2. Siphon elsewhere as yet brake fluid from the master cylinder using a turkey baster. Loosen and remove the union nuts connecting the brake line to the hose. Then remove the retaining clip to pull the brake line from the hose.
3. Opt for steel lines, rather than copper, when replacing your fuel lines. Bend the brake line carefully then replace the retaining clip and reconnect the brake line to the house. Make sure the replacement lines are the same length as your old lines.
4. Top off the master cylinder with brake fluid before bleeding the brake system by removing the cap on the bleeder valve's caliper. Fit a length of clear plastic tubing over the valve, placing the other end into a clear container. Instruct your partner to pump the brake pedal as you turn the bleeder screw to bleed the brake system. Do this until you don't see any air bubbles in the fluid pouring into the container.
5.1. Jack up your vehicle using a floor jack and put a advice stand under Everyone revolve. Consult your owner's volume to cinch a protected jacking position.
