Be trained apply an arc welder.
Arc welding may be the reimburse whether you occasion to accompany two pieces of metal well-adjusted and desideratum a big, permanent Seam. Arc welding uses electricity to melt the welding rod news, which blends with the replica metal that you are working with. A Seam that has been arc welded may be as Powerful or stronger than the surrounding metal. The arc welder is grounded to the metal you are working with, and when you touch the welding rod to the attempt globe, an arc is created and the plan is completed.
Instructions
1. Don weighty welding gloves. Practice a deluxe level welding helmet, as looking at welding arcs without Safeguard can argument damage to your eyes. Wear a long-sleeved shirt and extensive pants, as your skin can be burned from the arcs. Wear ponderous boots to protect your feet.
2. Prepare the nature to be welded by grinding off any rust, scale, dirt, or dye with a metal grinder.
3. Squeeze the alligator clamp on the grounding cable from your welder cool with your handwriting. Attach the clamp to a metal bite of the group you are welding, on the other hand far Sufficiently outside that the clamp and attaching cable Testament not be damaged by welding arcs. Turn the welder’s power switch on. Ownership the rod to the chore at a ninety-degree angle. Before welding can enter upon, you must strike an arc, which is the arc of electricity that comes from the welding rod to the metal existence welded. Begin your arc by tapping the rod against the metal and then back up again, or by striking the rod coextensive a match against the metal.
Proceeds the clamp.
5. Turn the amp setting on your welder to 70 amps. Proceeds the clamp.4. Plug the welder’s power cord in. Squeeze the clamp on the welding rod holder and cover a rod into the maw.
6. Ownership the rod away from the metal being welded the same distance as the diameter of the welding rod. Steadily move the rod across the area to be welded. Do not remain in one area for too long or you will burn a hole in the metal or overheat it to the point that it warps or distorts. (Note: If you lose the arc, you are probably holding the rod too close or too far away from the work. Strike your arc again and continue.)
7. Pull the rod back from the work when you have completed the weld. Turn the welder’s power switch off. Remove the slag (which is welding rod residue) from the weld by rapping the weld with a hammer until the slag breaks free and falls off.
