Rust holes
are repaired with patches.
Rust holes ensue in the item panels of cars after consistent exposure to moisture, damp or flavour dilute. These holes birth as limited holes in the emulsion which leads to corrosion that eats out at the metal from the edges of the gap outside. To repair rust holes in a vehivle, the corrosion must be stopped, then the gap complete. This is the by oneself habit to completely remove and repair the damage.5. Apply auto body putty over the metal patch with a plastic scraper forming a substantial layer of putty at least 1/4 inch thick across the surface of the patch material. Let it dry for six to 12 hours.
Acquisition the edges of the rust gap by carefully inspecting the all-inclusive panel front and back. Aim the ends of the gap with a clouded hoodoo marker.
2. Incision away the rusted metal using a metal adage, later your marks. Inspect the edge of your cut to ensure that there are no signs of rust inside the metal beyond the edge of your cut.
3. Clean the edges all around the hole you have cut with a degreaser. Rinse thoroughly and then sand the edges with a low grit metal sandpaper.
4. Cut out a metal mesh patch slightly larger than the size of the hole you just cut in the car. Apply this to the inside of the vehicle panel, covering the hole, with a metal adhesive.
Otherwise, the rust Testament endure and the gap Testament branch out.
Instructions
1.6. Sand the dried putty with a low grit sand paper until it is flush with the adjoining panel material. Rinse clean with water and let dry.
7. Apply a coat of automotive primer to the bond area. Let it dry and then apply another coat of matching automotive paint to finish the panel.
