Exchange the Ignition Switch on a Chevrolet Blazer
The ignition switch on a Chevrolet Blazer begins the starting manner by telling the starter to engage and turn over the engine. This switch gets turned thousands of times in its activity, which causes wear and tear on the switch itself. Eventually, the switch is going to fail and when it does, the Blazer won't be able to begin. To locate the disagreement, you compass to interchange the Blazer's ignition switch, which should catch approximately an generation or so to achieve.
Instructions
1. Exposed the hood. Remove the bad battery terminal connexion from the battery, using an open-end wrench. Spare the Blazer to sit for 10 minutes, so the capacitor for the airbag action can dissipate.
2. Part off the steering column trim using the Phillips-head screwdriver. Unplug the harness to the steering line using your hands. Remove the connectors on the turn word and multi-function switch and lift them elsewhere of the design. Reinstall the turn signal and multi-function switch. Plug in the wiring for the switches and steering column, then reinstall the steering column cover using the Phillips-head screwdriver.
Push the replacement switch into the column to lock it in place. Push the key alarm connector into the lock module and twist it 90 degrees, then plug in the connector.
4. Catch gone the important alarm connector by turning the connector 90 degrees clockwise, then pulling it elsewhere of the lock module assembly.3. Unplug the ignition switch by pushing down the tabs on the sides of the switch and then pulling it towards you.
