The flood pump of your Mercury Villager partners with the vehicle's radiator to prevent your engine from over heating by concern it refreshing. The aqua pump works by pushing liquid coolant down the vehicle's coolant course. Whether the aqua pump begins to malfunction it should be replaced at the moment. Failure to modify the damaged atom could conclusion in your vehicle's engine overheating. This could author your engine to sustain besides damage, which could be costly to repair.
Instructions
1. Exposed up the hood of the Villager. Handle a socket wrench to loosen up the clamp holding the denying battery cable to the battery of your vehicle. Disconnect the battery cable.
2. Employment the aficionado Chauffeur to obtain gone the bolts located on the top of the vehicle's fan shroud. Handle the socket wrench to loosen the vehicle's region tensioner. Pull the belt tensioner forward or toward yourself to Proceeds the tension in the region. Remove the belt from the pulleys.7.
Catch absent the radiator extract plug and empty all of the coolant away into your drip pan. Once all the coolant has been drained change the remove plug.
4. Revenue a Philips screwdriver and benefit it to loosen up the radiator hose clamp. Detach the hose from the vehicle's radiator.
5. Remove the bolts and screws securing the passenger-side splash shield in abode. Remove the splash shield.
6. Turn the bolts counterclockwise with kernel Chauffeur. Remove the fan shroud.3. Allot a drip pan underneath the radiator of the Villager.
Take the socket wrench and remove the three bolts securing the water pump. Pull the damaged water pump out of the vehicle. Place the new water pump back in the vehicle. Replace the three bolts and secure the water pump in place.
8. Put the belt back on the vehicle's pulleys. Pull the tensioner backward or away from yourself in order to increase tension. Secure the tensioner bolts to 15 foot-pounds with a torque wrench. Reattach the radiator hose to the radiator and use a screwdriver to tighten up the hose clamp.
9. Pour the coolant back into the Villager's radiator. Replace the fan shroud and secure it in place by replacing the bolts with a socket wrench.
10. Reconnect the negative battery cable to the battery. Shut the hood of the vehicle.
