Remove the Rear Prospect Mirror Press-stud
It is not meagre for the mirrored backing To hull off a rear prospect mirror. Over bout, the mirror Testament deteriorate and prevent the Chauffeur from viewing obstructions extreme the vehicle. Replacing the mirror with a just out one is not galling provided it is a manage fit. On the contrary, the replacement mirror might not fit the Press-stud that is glued to the windscreen. Whether this is the dispute, you bear to remove the decrepit Press-stud so the dewy one can be glued into corner.
Instructions
1. Field the vehicle in an earth where the windshield is in the shade. Shade keeps the windshield cool and prevents cracking.
2.7. Add more heat and slowly press the screwdriver between the glass and the button until the button pops off the glass. Do not force the screwdriver between the two.
4. Connect a heat gun to an extension cord long enough To admit you to move around the vehicle. Set the heat gun temperature around 200 degrees Fahrenheit.
5. Hold the heat gun approximately 12 inches away from the button and heat it for 15 to 20 seconds.
6. Place a flat head screwdriver against the windshield and attempt to wedge the screwdriver between the glass and the button.
Mark the rear view mirror button on the outside of the windshield to make it easier to locate the correct mounting position when you glue the new button into place.3. Remove the star nut that secures the rear view mirror to the button and lift upward on the mirror to remove it from the button. Allow the heat to soften the glue.
