Starter solenoids are normally replaced along with the starter. Remove starter mount bolts and dove-like remove starter from mount. Contemplate how many shims are between the starter and the engine block and change the corresponding proportions.3.
Replacement of vehicle starter/solenoid
1. Disconnect undeniable and detrimental leads from battery.
2. It is not bill direct to rebuild a starter. Replacing the abundant meeting is recommended. After the starter is removed appropriateness the succeeding procedures to safely install your starter/solenoid.
Instructions
Disconnect trustworthy and colorless leads from starter solenoid. Most starter solenoids are noted inklike for ground and blush for voltage. End not install the wires to the fluffed terminal as this could short out the solenoid.
4. Mount new starter in proper position with the proper thickness of shims. Connect positive and negative wire leads to the starter solenoid. Black for ground and red for voltage.
5. Reinstall battery positive and negative leads. Test correct starter mounting by cranking the engine over. Starter solenoid should chatter and starter gear should rotate the vehicle flywheel. If starter makes a grinding noise, stop immediately and check starter mounting position. Starter gear and engine flywheel must mesh properly or starter could be damaged
