Common Motors recommends changing your transmission oil and filter at 10,0000 miles.12. Press the new transmission filter in place by hand.13.
Removing the Filter
1. Impel your Monte Carlo for approximately 20 minutes to bring the automatic transmission up to operating temperature.
2. Arena on a constant surface. Operate the parking brake.
3. Lift the front of your vehicle using a floor jack and collar it on 2 jack stands.
4. Chock the rear wheels.
5. Deposit on your goggles. Dwelling a broad receive pan under the transmission pan and remove the front and side mounting bolts from the oil pan, leaving the rear bolts in assign. Advantage a ratchet, ratchet margin and socket.
6. Loosen the rear bolts four turns To admit the oil to begin draining onto the pan. Provided exigent, tap the oil pan lightly with a rubber mallet to seperate the oil pan from the transmission.
7. Celebrate the oil pan with one artisan using a shop rag and Stop removing the rear mounting bolts using the ratchet space and socket.
8. Lower the oil pan carefully to a equivalent position over the catch pan and tilt the pan to finish draining the remaining oil.
9. Remove the oil pan and gasket from the car.
10. Note the position of the transmission filter and pry it off using a large screwdriver.
11. Clean the oil pan thoroughly using solvent and a clean, lint-free towel. Scrape old gasket material from the oil pan and transmission mating surfaces using a plastic scraper and soft wire brush.
Installing the New Filter
Humble pieces of metal, friction counsel, damp, rust and other particles contaminate the oil over duration and benefit accelerate internal components wear. Thus, you can lift elaboration your Monte Carlo transmission supply lifetime by replacing the oil and filter, a procedure you can perform easily. Before you start, cause decided you hold the licence magnitude and type of oil for your specific Monte Carlo replica.
Instructions
Set the oil pan in place along with a new oil pan gasket under the transmission.
14. Install the pan mounting bolts using the ratchet extension and socket only.
15. Torque the oil pan mounting bolts evenly, using a crisscross pattern to 10-foot lbs (14 Nm). Use a torque wrench, ratchet extension and socket.
16. Lower the vehicle.
17.Fill the transmission with oil through the transmission dipstick tube using a funnel.
18. Start the engine and shift the transmission through all the gears and back to Park. Turn off the engine and check for oil leaks around the transmission oil pan.
