One of the worst matters that happen to a lovely stain billet is getting chips in it. Chipped colouring may not be noticable to most folk, however the bike's owner can't discern the motorcycle without seeing the chips. Repairing chipped dye is not indurated and can be done a couple of contrasting ways. Enroll repair chips in a motorcycle tint employment with a pen or brush and obtain your distemper looking prize it should.
Instructions
1. Sand the edges of the chipped dye with the 800 grit sandpaper stick pen. Apartment the gratuity of the pen on the chip and act it back and forth and left to honest. Most chips extent down to the naked metal, so the metal and the edges of the distemper must be sanded smooth to make a added still surface. Provided the edges of the dye are not sanded, a insolvable column will show once the paint has dried. If the paint touches smooth, unsanded bare metal, it will eventually flake off because paint does not adhere well to smooth bare metal.
2. For slightly larger chips, use the same dabbing technique so that enough paint gets into the chip, and then use a brushing stroke to smooth the paint. Let the paint dry for 30 minutes. Apply a coat of clear coat touch up paint using the same method. Allow it to dry for a few hours before handling the area. A microfiber towel will not leave lint on the surface.
3. Shake the touch-up paint well before opening it so that it is properly mixed. For small chips, just use the tip of the paint pen or paint brush to touch or dab the chipped area until it is covered. Wipe the sanded area with wax and grease remover using a microfiber towel. This removes any dirt, dust, wax or grease particles left behind. Fingerprints leave grease that ruin paint after it has dried.
