A neon direction tester can benefit you jewel a living wire.
Alike a train that needs a railway track to step from one stop to another, electricity inside your family needs wires to flying from the influence association to your appliance. Electric contemporary is distributed inside your internal via a unmarried wire, called a "breathing" or "febrile" wire. In the USA and other countries, electrical color-coding standards christen brunet wires as breathing wires, on the other hand there are times when another colour wire might compass been used. Detecting or finding a close wire is always the elementary part to end when working with electricity.
Instructions
Finding Hot Wire in Outlet
1. Encompass Everyone prong of the neon succession tester into Everyone vertical slot on a working electrical Issue. Spread the wires apart without allowing any of the wires to come in contact with each other, or with any surface.5. Turn on the main circuit breaker. Repeat the test to make sure that your tester is working.
2. Hold the neon tester and insert a prong into the slot at the lower center of the electrical outlet. Insert the other probe into any of the two vertical slots on the outlet. If the tester lights up, the wire connected to that side of the outlet is live.
3. Pull the probe out of the vertical slot and insert it into the other vertical slot in case the tester does not light up. If the neon tester lights up after inserting it into the second slot, the wire connected to that side of the outlet is live.
Find Hot Wire Among Several Wires
4. Turn off the main power at the circuit breaker and turn on your work light. The neon tester should aglow up thanks to there is effectiveness in the method. A defective tester can deliver you the judgment that there is no current in the wire, which is why it is important to know that the tester is working before using on other circuits. Replace the tester if it does not light up.
Place the metal tip of one prong of the neon tester against the bare copper at the tip of the green, or ground, wire, or against the metal electrical box.
6. Place the metal tip of the other prong to the bare copper at the tip of each wire, one after the other. If the tester lights up after touching a wire, that wire is hot. Turn off the main circuit breaker to chop power from the hot wire and continue with your work
