The Mitsubishi Galant is one of the scarce vehicles that doesn't enjoy the parking brake transaction incorporated into the rear CD brakes. This way that the rear and front brake systems drive the duplicate street, production them elementary to moderate.
Instructions
Removal
1. Withdraw half of the brake fluid from the crack cylinder reservoir. Manipulate a syringe to siphon half of the fluid from the reservoir. Place it aside to alternate any binding fluid after you moderate the brakes.
2. Elevate the Galant from the ground using a automobile jack. Block the vehicle on all sides. Trial for any children or animals that may crawl under the machine.
3. Disassemble the turn meeting. Loosen the lug nuts with a torque wrench and remove the spin. Allot is on the ground face up to prevent damage.
4. Catch off the caliper criterion and lock pins, and then remove the caliper meeting from the caliper cornerstone. Secure the caliper with wire to keep it out of your way.
Grease the areas that slide together using silicone based grease.7. Install the new brake pads, shims and spring clips onto the caliper support. Position the caliper over the brake pads.
Installation
6. Compress the piston in the bore using a C-clamp.5. Withdraw the brake pads, spring clips and shims. Keep the disc on the hub by putting the wheel lug nuts onto the studs without over tightening.
8. Lubricate the caliper guide and locking pins. Install in the position they were before removal.
9. Use a torque wrench to tighten the guide and locking pins to 20 ft. lb. and then remove the C-clamp. Replace the wheel assembly and lower the Galant to the ground. Check the brake fluid level and verify that the brakes function properly.
